Remark Knowledgebase

Knowledgebase Home > Remark Classic OMR > Error Codes/Messages | Glossary | Favorites | Contact

View Questions by Category

There are no sub categories

Error Codes/Messages

There were 6 questions found in this category:

An error message just appeared while I was using Remark. What should I do?
Your error may be in this knowledgebase already. Check if it is and follow the advice given in the article. If not, there is an index of possible errors in the back of the User's Guide that is downloaded with the software. Look up your error message there and see if you can determine the cause ...
Error 9000
An Error 9000 is a very general non-specific error that can be caused by a variety of conditions. For this reason it can be difficult to pin point the source of the problem. Often times it results from a missing or incorrectly registered file needed for the software. The first thing we suggest ...
How do I fix "2147219705: An error occurred instantiating the authentication object during installation"?
If you are installing the software and see this error:Error 2147219705: An error occurred instantiating the authentication object. Please reboot your computer and they retry the installation.The most likely reason is that you are using an older version of software on Windows 7. The following Rem ...
How do I solve Error 2147023898. Automation Error. Invalid Access to Memory Location when opening Remark Classic OMR?
In July 2011 Microsoft released a Windows 7 security update, KB 2507938, which causes an error to appear when opening Remark software. This error states:Automation ErrorInvalid Access to memory locationIf you receive this error after installing this Windows 7 security update, you will need to do ...
Sekonic SR 1800 Error: An error occurred opening the USB port. Make sure the cable is plugged in and has power.
When the USB driver is installed for the Sekonic scanner, the software will assign a non-physical port like Com5 or Com7. To instruct Remark Classic OMR on which port to use: 1.Locate the device driver by going to the System Icon in the Windows Control Panel and see what com port was assigned ...
When I try to save to Excel or Access I get Error -2147467259: Too many fields defined
Check to see if you have more than 255 columns of data in your data set. Even though Excel 2007-2010 supports more than 255 columns, the third party connection that Microsoft provides to software vendors currently does not. If you have more than 255 columns, you will need to export your data by ...